Ultimate power and performance in a small package best describes the new F1 Series clutch and gear pumps. Our pressure-balanced wearblocks and sleeve-type bushings provide both high performance and extra long life. The F1 Series is designed exclusively for those low flow applications.

• Solid one piece shafts
• Dowel pin construction
• SAE spline or round keyed shaft
• Sleeve type bushings
• Full one year warranty
• Speeds to 3500 RPM
• Pressures to 4000 PSI
• SAE straight thread 0-ring ports on either side or rear
• 7 standard sizes (Clutch) from 1.6 to 5.02 GPM*
• 11 standard sizes (Gear) from 1.6 to 8.7 GPM*

*GPM @ 1000 RPM

Heavy-duty cast iron construction. Completely rebuildable. One year warranty.

This pump operates from direct engine power. A dash-mounted switch permits convenient control. No PTO is required. Speeds to 4000 RPM, with pressures to 3500 PSI. Standard sizes: 3, 5, 7, 9, 11 GPM @ 1000 RPM. Solid one piece shaft. Integral mounting pad. Both side and rear ports make installation easier.

The Mounting Kit has a bolt pattern specially designed for Muncie Clutch Pumps. Packaged with all parts, belts, and hardware for easier installation.

All cast iron construction. Heavy-duty roller bearings. One year warranty.

• Both side and rear ports
• Bi-rotational operation
• High pressure motor seals
• Solid one piece shafts
• Motor case drain
• Speeds to 3600 RPM
• Pressures to 3000 PSI
• 3 standard shaft sizes
• 3 standard mounting flanges
• 7 standard sizes: 4, 6, 8, 11, 13, 15, 17 GPM*

*GPM @ 1000 RPM

All cast iron construction. Heavy-duty roller bearings. One year warranty.

• Both side and rear ports
• Bi-rotational operation
• High pressure motor seals
• Solid one piece shafts
• Motor case drain
• Speeds to 3600 RPM
• Pressures to 3000 PSI
• 2 standard shaft sizes
• 2 standard mounting flanges
• 7 standard sizes: 14, 16, 19, 23, 25, 27, 30 GPM*